This NTI E-LDS10-100 Legacy Liquid Detection Rope Sensor - Length of water sensor cable - 10 ft. Length of 2-wire cable - 100 ft. are available for simple connection to either the "Digital In" terminals (use model E-LD or E-LD-LC) or the "RJ45 Sensor" ports (use model E-LDS).

Connect the two-wire cable (up to 1000 feet long) from a liquid detection sensor (E-LD shown in Figure 2-upper image) to a set of "DIGITAL IN" contacts. For added range (up to 1000 more feet), use an E-LDS (shown in Figure 2-lower image) and connect to an "RJ45 Sensor" port.

The twisted orange sensing cable should be placed flat on the surface (usually the floor) where liquid detection is desired. If tape is required to hold the sensor in place, be sure to only apply tape to the ends, exposing as much of the sensor as possible. At least 5/8" of the sensor must be exposed for it to function.

NTI E-LDS10-100 Legacy Liquid Detection Rope Sensor - Length of water sensor cable - 10 ft. Length of 2-wire cable - 100 ft. Features:

• For detecting water presence and warning of flooding.
• Detects liquid depth >0.1" (2.5 mm).
• Minimum puddle: 0.6" (15 mm) diameter.
• 100% waterproof electronics.
• Detects any liquid or moisture, except deionized water.
• Features a non-conductive polymer mesh that prevents false alarms caused by dirt/dust buildup, metal contact, or pressure on the rope

Why not buy this NTI E-LDS10-100 Legacy Liquid Detection Rope Sensor - Length of water sensor cable - 10 ft. Length of 2-wire cable - 100 ft. today?