This NTI E-LD-LC100-100 Low-Cost Liquid Detection Sensor, Rope-Style - Length of water sensor cable - 100 ft. Length of 2-wire cable - 100 ft. Connect the liquid detection sensor E-LD (E-LDx-y, E-LD-LCx-y, E-CDx-y) to a set of terminals (1-5) marked "DIGITAL IN". The twisted orange sensing cable should be placed flat on the surface (usually the floor) where liquid detection is desired. If tape is required to hold the sensor in place, be sure to only apply tape to the ends, exposing as much of the sensor as possible. At least 5/8" of the sensor must be exposed for it to function.

NTI E-LD-LC100-100 Low-Cost Liquid Detection Sensor, Rope-Style - Length of water sensor cable - 100 ft. Length of 2-wire cable - 100 ft. Features:

• For detecting water presence and warning of flooding.
• 100% waterproof electronics.
• Detects any conductive liquid or moisture.
  • Water sensor cable cannot be in contact with any conductive surfaces or overlap on itself.
• Minimum puddle: 0.06" (1.5 mm) diameter.

Why not buy this NTI E-LD-LC100-100 Low-Cost Liquid Detection Sensor, Rope-Style - Length of water sensor cable - 100 ft. Length of 2-wire cable - 100 ft. today?