MuxLab 500753-TX HDMI / RS232 Over Ip Extender Kit With POE allows HDMI equipment to be connected up to 330feet (100m) @ 1080p via one (1) Cat5e/6 unshielded twisted pair cable in a point-to-point configuration. Point-to-multipoint and multipoint-to-multipoint is possible by connecting several Transmitters and Receivers to the same Ethernet network. The Transmitter (500753-TX) and Receiver (500753-TX) also support PoE (PD) if used with a PoE (PSE) Ethernet Switch. The kit comes with one (1) Transmitter and one (1) Receiver. The IR Emitter and IR Sensor, if required, may be purchased separately for remote control applications.
NOTE: This product has been discontinued. See the above SIMILAR Tab for equivalent products or, if not there, call us at 833-WOLFPACK (833-965-3722) right now to discuss your needs.
For the point-to-multipoint and multipoint-to-multipoint configuration the Ethernet switch must have Gigabit ports, DHCP Server capability and IGMP communications protocol. MuxLab recommends using the Cisco SG300 Series Managed Switches.The MuxLab Pro Digital Network Controller (500811) is available to simplify the configuration and utilization of the MuxLab IP based products via an Ethernet web interface, and supports third party management via smartphone and tablet.
MuxLab 500753-TX HDMI / RS232 Over Ip Extender Kit With POE Features:
- HDMI 1.3
- Supports up to 1080p resolutions
- Motion JPEG compression with Very low latency
- Supports 100's of Transmitters and Receivers, depending on network bandwidth
- Supports point-to-point, point-to-multipoint and multipoint-to-multipoint applications
- Transmission up to 330 ft (100m) over Cat5e/6
- Up to 390 ft (120m) between the TX and RX when no LAN switch is used
- Supports RS232 and IR transmission for remote control
- PoE powered
- Control via any web device (mobile, tablet) with use of model 500811 (Pro Digital Network Controller)
Why not buy this MuxLab 500753-TX HDMI / RS232 Over Ip Extender Kit With POE today?
MuxLab 500753-TX HDMI / RS232 Over Ip Extender Kit With POE
- Bandwidth : 225 MHz, 60 Mb/s
- Signal : HDMI 1.3a
- Connectors
- 1 x HDMI video output
- 1 x RJ45S, port
- 1 x 9-pin Sub-D, RS232 serial port
- 1 x 3.5 mm phone jack, IR sensor
- 1 x 4-position DIP switch, device ID addressing
- Range : Up to 330' (100 m) for 1080p on Cat5e/6 cable
- Network Requirements
- 100BaseT for point-to-point
- 1000BaseT for other configurations
- IR Frequency : 38 kHz
- PoE : IEEE 802.3af
- Power Consumption : 1.8 W
- Power Supply : 110 - 240 V, 5 VDC power supplies with interchangeable blades
- Temperature
- Operating: 32 to 104˚F (0 to 40˚C)
- Storage: -4 to 185˚F (-20 to 85˚C)
- Humidity: up to 95% non-condensing
- Compliance
- Regulatory: FCC, CE, RoHS
- Flammability: 94V0
- Dimensions : 4.4 x 3.0 x 1.0" (11.2 x 7.6 x 2.5 cm)
- Weight : 1.1 lb (499 g)
