This AIDA Imaging IPCOMM-POE Portable Wireless Video & Control Transmitter has never been the solution to live streaming.. That was until the IPCOMM-POE came along.
With the power to inject PoE+ power into any camera via DC12V or a NPF-Battery (not included), you can easily take your video creations wirelessly onto any Wi-Fi router, sending IP video or IP control flawlessly as far as your router can reach!
This solution brings a whole new level of broadcasting opportunity for on-the-go, non-mounting solutions! So bring on this revolution, and start streaming wireless today!
AIDA Imaging IPCOMM-POE Portable Wireless Video & Control Transmitter Features:
- Give any IP based camera wireless functionality to submit video or control over most WiFi based routers/networks.
- PoE+ injector to power any IP camera connected to (if supported)
- Capability of using DC12V power tap, or a NPF battery series to power the camera without use of DC12V port.
- Bottom of the IPCOMM-PoE has 3 1/4-20” mounting holes for perfect fitment
- Provides a wireless solution to hard-to-reach or unmountable camera setups in any workflow.
- Can be paired with multiple IPCOMM-PoE’s for multi-cam workflows.
- Performance based off of overall bitrate, not resolution. Keep in mind of these rules:
- Limit the amount of obstacles between the router and IPCOMM-POE
- Ensure the signal strength seen when setting the IPCOMM-POE up is above 60%
- Ensure the bandwidth sent by the camera to the router is within 2Kbps~50kbps, this mostly depends on your signal strength. Anything higher will cause delay and video rupturing.
- To avoid power loss, plug in DC12V to keep IPCOMM-PoE running, anda swap batteries if needed.
Why not buy this AIDA Imaging IPCOMM-POE Portable Wireless Video & Control Transmitter today?
AIDA Imaging IPCOMM-POE Portable Wireless Video & Control Transmitter Specifications:
- TRANSMISSION
- Antennas: 4 x 3dBi Dual Band Omni-Directional
- Wireless Standard: IEEE802.11ac/a/b/g/n
- Transmission Rate: Up to 80 Mbps
- RF Parameters: Receiver Sensitivity: -96dBm, Freq: 2.412~2.472GHz 5.180~5.725GHz
- Channel Bandiwdth 20/40/80 MHz, AUTO
- Encryption: WPA-PSK / WPA2-PSK / WPA/WPA2
- PHYSICAL
- Physical Ports: RJ45 Port, 12VDC port, NPF Battery Slot
- Case: Hardened Aluminum
- PoE+ Port Standard: Up to IEEE 802.3at
- Indicators: PWR, PoE+ and NPF Battery Status
- Switch: On and Off
- Operating Temp: 0°C ~ 55°C
Why not buy this AIDA Imaging IPCOMM-POE Portable Wireless Video & Control Transmitter today?
AIDA Imaging IPCOMM-POE Spec Sheet